Question: 11
Which statement about the IP SLAs ICMP Echo operation is true?
A. It is configured in enable mode.
B. It is used to determine the one-way delay between devices.
C. It is used to identify the best source interface from which to send traffic to a destination.
D. The frequency of the operation is specified in milliseconds.
Answer: C
Cisco 200-105 Study Material
Friday, 8 December 2017
Tuesday, 14 November 2017
Cisco 200-105 Dumps Question Answers
Question: 10
What command visualizes the general NetFlow data on the command line?
A. show ip flow export
B. show ip flow top-talkers
C. show ip cache flow
D. show mls sampling
E. show mls netflow ip
Answer: C
What command visualizes the general NetFlow data on the command line?
A. show ip flow export
B. show ip flow top-talkers
C. show ip cache flow
D. show mls sampling
E. show mls netflow ip
Answer: C
Thursday, 9 November 2017
Cisco 200-105 Exam Questions
Question:9
The output of the show frame-relay pvc command shows "PVC STATUS = INACTIVE". What does this mean?
A. The PVC is configured correctly and is operating normally, but no data packets have been detected
for more than five minutes.
B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address
of the remote router.
C. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to
trigger a call to the remote router.
D. The PVC is configured correctly on the local switch, but there is a problem on the remote end of
the PVC.
E. The PVC is not configured on the local switch.
Answer: D
The output of the show frame-relay pvc command shows "PVC STATUS = INACTIVE". What does this mean?
A. The PVC is configured correctly and is operating normally, but no data packets have been detected
for more than five minutes.
B. The PVC is configured correctly, is operating normally, and is no longer actively seeking the address
of the remote router.
C. The PVC is configured correctly, is operating normally, and is waiting for interesting traffic to
trigger a call to the remote router.
D. The PVC is configured correctly on the local switch, but there is a problem on the remote end of
the PVC.
E. The PVC is not configured on the local switch.
Answer: D
Thursday, 26 October 2017
Cisco 200-105 Sample Questions
Question: 6
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
A. hop count
B. administrative distance
C. link bandwidth
D. link delay
E. link cost
Answer: B
Question: 7
At the end of an RSTP election process, which access layer switch port will assume the discarding role?
A. Switch3, port fa0/1
B. Switch3, port fa0/12
C. Switch4, port fa0/11
D. Switch4, port fa0/2
E. Switch3, port Gi0/1
F. Switch3, port Gi0/2
Answer: C
Question: 8
Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two.)
A. CHAP uses a two-way handshake.
B. CHAP uses a three-way handshake.
C. CHAP authentication periodically occurs after link establishment.
D. CHAP authentication passwords are sent in plaintext.
E. CHAP authentication is performed only upon link establishment.
F. CHAP has no protection from playback attacks.
Answer: B, C
Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being used?
A. hop count
B. administrative distance
C. link bandwidth
D. link delay
E. link cost
Answer: B
Question: 7
At the end of an RSTP election process, which access layer switch port will assume the discarding role?
A. Switch3, port fa0/1
B. Switch3, port fa0/12
C. Switch4, port fa0/11
D. Switch4, port fa0/2
E. Switch3, port Gi0/1
F. Switch3, port Gi0/2
Answer: C
Cisco 200-105 Dumps Download New 200-105 Question Answers
Question: 8
Which two statements about using the CHAP authentication mechanism in a PPP link are true? (Choose two.)
A. CHAP uses a two-way handshake.
B. CHAP uses a three-way handshake.
C. CHAP authentication periodically occurs after link establishment.
D. CHAP authentication passwords are sent in plaintext.
E. CHAP authentication is performed only upon link establishment.
F. CHAP has no protection from playback attacks.
Answer: B, C
Thursday, 12 October 2017
Cisco 200-105 Question Answers
Question 1
What is a valid HSRP virtual MAC address?
A. 0000.5E00.01A3
B. 0007.B400.AE01
C. 0000.0C07.AC15
D. 0007.5E00.B301
Answer: C
Question 2
What OSPF command, when configured, will include all interfaces into area 0?
A. network 0.0.0.0 255.255.255.255 area 0
B. network 0.0.0.0 0.0.0.0 area 0
C. network 255.255.255.255 0.0.0.0 area 0
D. network all-interfaces area 0
Answer: A
Question 3
When a router undergoes the exchange protocol within OSPF, in what order does it pass
through each state?
A. exstart state > loading state > exchange state > full state
B. exstart state > exchange state > loading state > full state
C. exstart state > full state > loading state > exchange state
D. loading state > exchange state > full state > exstart state
Answer: B
Question 4
What are three characteristics of the OSPF routing protocol? (Choose three.)
A. It converges quickly.
B. OSPF is a classful routing protocol.
C. It uses cost to determine the best route.
D. It uses the DUAL algorithm to determine the best route.
E. OSPF routers send the complete routing table to all directly attached routers.
F. OSPF routers discover neighbors before exchanging routing information.
Answer: A, C, F
Question 5
Which command do you enter to view EIGRPv6 adjacencies?
A. show ipv6 eigrp 1 interface
B. show ipv6 route eigrp
C. show ipv6 eigrp neighbors
D. show running-configuration eigrp
Answer: C
What is a valid HSRP virtual MAC address?
A. 0000.5E00.01A3
B. 0007.B400.AE01
C. 0000.0C07.AC15
D. 0007.5E00.B301
Answer: C
Question 2
What OSPF command, when configured, will include all interfaces into area 0?
A. network 0.0.0.0 255.255.255.255 area 0
B. network 0.0.0.0 0.0.0.0 area 0
C. network 255.255.255.255 0.0.0.0 area 0
D. network all-interfaces area 0
Answer: A
Question 3
When a router undergoes the exchange protocol within OSPF, in what order does it pass
through each state?
A. exstart state > loading state > exchange state > full state
B. exstart state > exchange state > loading state > full state
C. exstart state > full state > loading state > exchange state
D. loading state > exchange state > full state > exstart state
Answer: B
Latest Cisco 200-105 Question Answers Download PDF
Question 4
What are three characteristics of the OSPF routing protocol? (Choose three.)
A. It converges quickly.
B. OSPF is a classful routing protocol.
C. It uses cost to determine the best route.
D. It uses the DUAL algorithm to determine the best route.
E. OSPF routers send the complete routing table to all directly attached routers.
F. OSPF routers discover neighbors before exchanging routing information.
Answer: A, C, F
Question 5
Which command do you enter to view EIGRPv6 adjacencies?
A. show ipv6 eigrp 1 interface
B. show ipv6 route eigrp
C. show ipv6 eigrp neighbors
D. show running-configuration eigrp
Answer: C
Download Latest Cisco 200-105 Exam Question Answers PDF
Subscribe to:
Posts (Atom)
Latest Cisco 200-105 Exam Practice Questions
Question: 11 Which statement about the IP SLAs ICMP Echo operation is true? A. It is configured in enable mode. B. It is used to determ...
-
Question: 6 Which parameter would you tune to affect the selection of a static route as a backup, when a dynamic protocol is also being us...
-
Question: 11 Which statement about the IP SLAs ICMP Echo operation is true? A. It is configured in enable mode. B. It is used to determ...
-
Question 1 What is a valid HSRP virtual MAC address? A. 0000.5E00.01A3 B. 0007.B400.AE01 C. 0000.0C07.AC15 D. 0007.5E00.B301 Answer...